***The following was on a Hyper-V vm, but this also applies to VMware.***
****This should work on most versions of Windows (doesn’t have to be SBS)****
The other week we picked up a new client with an emergency issue. They had an SBS 2011 Server on failing hardware. The hardware was so bad that we didn’t think it would last until the replacement server would arrive. We had an older Server that had enough power to handle their server virtualized until their new hardware arrived. So I started the virtualization process. This is where the fun began. (There were several issues minor issues, but I’ll stick to the major problem here.)
After creating the vm without any disk drives, I attached the newly created drives and powered up the vm and was greeted by the BSOD: STOP 0x0000007B.
Luckily there is an easy fix for this and you don’t need restart the p2v.
- Boot the vm off any Windows CD/DVD (Windows 7 & up. Doesn’t have to be the same OS as vm. You could also mount the drive on the host or another vm. If you mount the drive, just run regedit)
- After booting off OS cd, when you encounter the language selection, hit Shift-F10 for a command prompt
- At the command prompt, run regedit
- In regedit, highlight Hkey_Local_Machine
- With Hkey_Local_Machine highlighted, goto File, and Load Hive
- In Load Hive, select the drive letter where Windows OS was installed (C: in this case), then go to: Windows\System32\config\system
- Name the Hive whatever you want (IE: recovery)
- Expand HKEY_LOCAL_MACHINE\recovery\ControlSet1\Services\intelide
- Change the data for value “Start” from “3” to “0”
- Now goto File and “Unload Hive” (If you run into issues make sure Hkey_Local_Machine is highlighted)
- Exit regedit and reboot the machine and you’re good to go
If you still have issues after reboot, check the following keys and set them to:
Aliide = 3
Amdide =3
Atapi = 0
Cmdide = 3
iaStorV = 3
intelide = 0
msahci = 3
pciide = 3
viaide = 3